Showing posts with label plumbing. Show all posts
Showing posts with label plumbing. Show all posts

Friday, April 10, 2015

A table a day...

It would seem that many of my projects involve 10% perspiration, 90% Pinspiration. These two little tables are no exception.

I was browsing my favorite image based bookmarking site when I came across this eye catching and simple solution to a DIY side table.


Originally put on Pinterest by Home Depot, this table was exactly the kind of quirky piece of furniture I was looking for to go between my chairs in what has recently been dubbed The Salon. (That is, the area that was the original dining room in the house, but is now just an awkward spot off of the kitchen.)

I checked out the DIY instructions for the table here, then looked online to see how much this baby would cost. Due to the fact that it was 30 ft of copper pipe, it would cost the same to buy something pre-made as it would to build it.

I showed Casey the pin and she came up with the simplest answer: PVC. Use PVC to make it, then just spray it copper for the look!

DUH! Of course!!!

PVC was a mere $2.21 per 10 ft vs $11 per 10 ft of copper pipe of the same width. I purchased 3 PVC pipes and brought them home.


I used some painters tape to tape all three together, making sure they are all lined up with each other. I then marked 12 in. and cut them with a jigsaw. I continued this until I had the 30 pcs it asked for.


There might be some rough edges on your pipes. These can be cleaned up with an X-acto knife.

I then brought all the pieces inside and began putting them together. I ended up using the image more then the instructions, but either way, it's not too difficult. I also used heavy gauge wire rather than twine, I felt that it would make the table more stable.


When it was completed, it looked pretty good. This is the hardest part of the project and it doesn't really take that long to do.

To make sure that it would at least be sort of level and wouldn't fall over as soon as it had a table top, I used an old shelf from my office and a lamp to see how sturdy it was. It was actually surprisingly solid, so I was able to move on with the finishing steps.


I knew that I wanted to paint my PVC, so I decided to prime over all of the areas that had red writing. To make it easier on myself, I hung the entire base from the garage ceiling and used my spray primer from there.

Notice outside: "Weather"


While it was drying, I was able to run to the Depot and grab a table top. They had them premade out of pine in the lumber area. The smaller size was about $5.88 while the larger size was $6.88. I had waiting until the base was made to get the right size, so I knew that the larger of the two options was right for me. Keep in mind, I also cut my struts to a foot in length instead of the ten inches that the instructions originally called for, so if you are making the other size, you might get away with the smaller table top.)

I stained it and sealed it using stain that I already had on hand.

I checked on my primed PVC and the red lettering was fighting my primer, but I figured it would probably be rough enough to take the copper paint. I ended up at Hobby Lobby because apparently copper paint isn't as common as silver or gold. My issue was that I wanted bright copper, not rusted, aged, or hammered copper.


I gave the entire base a good coat.


Once everything was dry, I attached the bottom to the top with copper brackets that I had purchased for my 3/4 in pipe. I only had to use three. I also used screws instead of the nails that came with the brackets.

When I was finished, I was pretty pleased. It looked a lot like the picture.



And the copper paint really helped pull it together, especially with the rug that I purchased to replace our old one.


The Salon was looking pretty good.


And today I decided to make a simple table top for an empty planter in the backyard. It's now a spiffy place to put a drink or popcorn while sitting next to the fire.


The cost was $0 because I just used a couple of pieces of scrap wood.

What do you think? Would you venture to try making either one of these? There are so many possibilities with the basic elements of them that no two tables need look alike!

Thursday, March 5, 2015

Living a Life of Vanity

This is truly one of the most wonderful times of the year. I am referring, of course, to Tax Return Season. The season that allows you to accomplish that thing or things you can't do for the rest of the year. The season of promise, hope, and at least for us, home improvement.

For Scott and I, we used our tax return in many ways. One way has been overdue for a while.

Our master bathroom has always reminded me a bit of a men's gym bathroom. The sink attached directly to the wall with no cabinet. The tile was old and a horrible color blue. The tub was practically stained yellow. It needed some work.

Avid readers of the blog will recall that I have already painted the tile and walls in there. It was a nice fix for a while, but unfortunately, it did not last. Using the sample pots of paint meant that they were matte finished. When we took showers, the paint would literally drip from the walls, leaving marks and really gross residue all over our tiny bathroom. Besides, I liked the color, but I was never in love with it. It was better than what was there, but it still wasn't at the top of its game.






Let's just say it still needed tweaking.

When we found out what our tax return looked like, we were able to say, "Okay, it's vanity time". Nothing could have made me happier than the day I realized that this bathroom had a future. To prep it, though, I wanted to get rid of the green. I was sitting in the living room the other day and I thought, "I bet the blue paint from behind the TV (of which I have half a gallon left) would look great in there". The dark color would be a nice contrast against the white tiles in such a light space plus, it was a gloss finish. One paintbrush purchase later and I was on my first step to a new room.



I even took some time out to fix our switch box. It had only ever been secured on one side, so I put a screw through the loose side. This meant that every time I unplugged something, the whole outlet wouldn't come out of the wall anymore.

It's the little things.


At this point, I had been shopping online for a vanity that fit our needs. We were aiming for under $200 with a lot of storage space, a white top, and a small footprint. I found this Glacier Bay vanity on Home Depots's website and I knew that it was the one.

Unfortunately, a couple of days later, it wasn't on the site anymore. My friend Laurie and I rushed over to the Depot and found that there was only one left. In Lexington. And it was the floor model. I was so happy they had any left, I went for it. I didn't see anything else I liked and to be frank, anything would be better than this.


Scott took little time in removing the old sink. It was attached to the wall through the tile with a large iron bracket, so once it was unhooked from the water and drainage pipes, it just lifted off the wall. We then took the faucet and drain out to reuse them on the new vanity. They were in perfect condition, so there was no use in spending extra money.


It's worth noting that during this bit of disassembly/reassembly, we had an audience watching from our bedroom.

Left to right: Scooter and Loki (who we were dogsitting) and Sam (Leela was in another room)

We brought in the new vanity and set it in place, making sure that it allowed access to all the water lines. We ended up having to purchase longer water supply lines because it is taller than the old sink. Scott also found a drain extender that looks like a bendy straw, allowing it to maneuver slightly to accommodate the space in the cabinet.

Once it was installed, we couldn't believe what an impact it made.


It has a toilet paper holder! There has never been a toilet paper holder in our bathroom before! And it's the correct height, so you don't feel like you're straining your back to wash your hands or brush your teeth. The couple of inches of counter space that surround the sink have acres of potential usable space compared to zero counter space with the old sink. Best of all is the cool shape of the sink entry and the awesome added storage of a slide out drawer at the top.


The whole room was really coming together, but there was something missing. I have been wanting to bring more plants into my home, but finding places for them where they will receive enough sun has been difficult. It occurred to be that a hanging plant in the bathroom would be a great addition to the space as well as a nice start to my indoor plant collection. Mom and I purchased a small $5 plant at Lowes which I then placed in a $5 ceramic planter I found at TJ Max. I plugged the hole in the bottom using a rubber wine cork and some caulking (at my Dad's suggestion). After purchasing some hemp twine, I followed this tutorial to create the hanger.

When Scott got home, he anchored and assembled the hook in the ceiling. Then I just planted the plant and hung it up. I love how it makes the room feel.


The whole room together feels so nice that I'm almost afraid to use it. I feel like someone is going to knock on the door while I'm taking a shower and tell me to get out of their bathroom. It just feels unreal how, in under a week, it has gone from feeling like a men's gymnasium locker room to an honest to goodness residential bath.


We also have more improvements that have taken place in the last week, but I'm saving those for another post. Make sure you like us on Facebook so you know when the next post is! It'll be a real SPLASH!

Tuesday, September 9, 2014

...and the kitchen sink

A month ago when I was in Tennessee helping Mom out around their new house, we took a trip to their local ReStore.

It was amazing. In some ways, life changing. They had all kinds of wonderful things from their area (which is surrounded by younger neighborhoods) that were barely used if not new. They also had a familiar Time And Relative Dimension In Space ship towards the back of the store that made me "SQUEEEE" for the rest of the visit.


As part of their inventory from this planet and time period, though, they had some impressive pieces. Large new windows, lots of window inserts for garage doors, and sinks. The sinks were all in pretty good shape and high in variety. They had some cast iron and white porcelain ones that were priced right. I managed to talk myself out of the purchase, though, and left empty handed (I did leave with my geeky heart was full).

Since my parents recently made another trip up to work on their future abode, they swung by the ReStore again and sent me a couple of pictures of any sinks that might interest me. One in particular was in great condition, the right size, and was only $45. Three days later, they pulled up in the driveway with a car full of everything...and the kitchen sink.

Scott and Dad decided to start installing it while Mom and I were running errands, so the pictures are kind of jumbled. I'll relay the play by play as it was described to me:

The old sink was not a looker. It was stainless steal, but very difficult to keep clean and always covered in water spots.


They began by turning off the water and dismantling the faucet.


Scott then played plumber underneath the sink and disconnected all of the hoses and pipes so that they old sink could come free of the counter without those hang ups.


When they tried to pull the old sink away from the hole, there was a bit of an issue. Not only was our old sink barely held in place, but there were rusted clips underneath that were more than happy to stubbornly stay put. Thank goodness we have tools like the Dremel to literally cut through those issues.


Once those were removed, so was the old sink. It had certainly seen better days.

Imagine food prep in this. Tasty.

Honestly, the kitchen already looked better with the old sink gone. (For anyone interested, this handsome disaster is on sale at our local ReStore for all of $10. Yikes!)


Once everything was kind of cleaned up, the new sink was brought in. We had measured it previously to make sure we wouldn't have to widen the hole in the counter, so we didn't really need to dry fit before installing.


The faucet base parts were attached to the new sink, and once the plumbers putty had been used around the hole, the it could be lowered in. The boys were glad to have it immediately off to the side because cast iron weighs a ton.


They managed to get it in without incident or smashed fingers.


After grabbing a couple of pieces of new PVC (so they would be easier to fit together), Scott crawled back into the cabinet to hook everything back up.


The rest of the faucet was reattached and we checked for leaks. After some minor adjustments, it was done!


Well...sort of...

It was still a used sink. It needed a little polishing.


Thankfully some Barkeeper's Friend cut right through the gross and we were set up to cook and clean in no time. I replaced the water filter, put the drying rack in the second basin, and we called it a day.


What a great find for $45! It is so nice to use because it just feeeeeeels clean.


(Thanks to Dad, Mom, and Scott aside from the normal DSLR for all the pictures in this post. Everyone had camera phones out for this one!)

Update: I have also managed to add two more finished doors to our hallway! It's hard to get a good picture of all three of them, so I'll just show you the cute half door that goes into the linen closet.

Aww.




The other door completed is to our bedroom. I'm thinking the master bath and the office doors will probably be next.

If you don't follow us on Facebook, you might not have seen the quick project I completed yesterday!


Pssst, it's made of straws, wire, and spray paint! You can find the tutorial to make one yourself here.

 http://www.vintagerevivals.com/2014/01/geometric-himmeli-wreath-2-0.html



And be sure to like us on Facebook!